Repairs
Repair & Maintenance
Steel doors dent, wood doors swell, and every door collects grit in its rollers. The repair and maintenance services meet each material where it is and put the moving parts back into good order without changing what the door is.
Which one do I need?
- Your toddler has discovered the wall button.Garage Door Safety Inspection
- On windy nights the door rattles in its frame, there is a line of daylight along one side, and the bottom seal has gone hard and flat.Garage Door Tune-Up
- You tapped the door with the bumper while backing in, barely a nudge, and now the bottom corner has swung inward.Off-Track Garage Door Reset
- After an overnight freeze the door stuck to the slab, the opener strained, and something gave.Garage Door Panel Replacement
- There are mouse droppings along the wall behind the recycling bins, and at one bottom corner of the door the vinyl has a neat chewed notch the width of a thumb.Garage Door Bottom Seal Replacement
- With the door closed and the garage lights off, a thin bright line runs down the whole left side of the opening.Garage Door Perimeter Weatherstrip
Repair & Maintenance
Inspection, adjustment, sealing, and section-level repairs.
Garage Door Safety Inspection
Springs, cables and drums, looked at and left alone
The counterbalance gets a careful look and nothing more during the inspection. On a torsion door the technician checks the spring coil for a gap, rust or a stretched section, confirms the cone set screws and centre bearing look sound, and follows each cable from the drum to the bottom bracket looking for broken wires, a rust bloom near the loop or a slack side. The drum wrap is checked for a single neat layer.
On an extension door the springs, pulleys and containment cables are examined the same way. Any adjustment to these parts is a separate, planned job matched to that system, torsion tension controlled with winding bars rather than simply released; the inspection records their condition.